AC/DC Power Outlet Control Module Replacement
AC/DC POWER OUTLET CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Move the drivers seat to the full rearward position.
3. Remove the 2 bolts (1).
4. Fold the floor carpet to the inside.
5. Disconnect the electrical connector (2).
6. Remove the accessory AC/DC power control module (3) from the vehicle.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the accessory AC/DC power control module (3) to the vehicle. Secure the module (3) with the 2 bolts (1).
Tighten
Tighten the power control module bolts to 7.0 N.m (62 lb in).
2. Fold the floor carpet to the inside.
3. Connect the electrical connector (2).
4. Move the drivers seat to it's original position.
5. Connect the negative battery cable.