Manual Transmission - MK5

Backup Lamp Switch Replacement

Removal Procedure

Notice: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch assembly.





1. Disconnect the backup lamp connector.
2. Remove the backup light switch assembly.

Installation Procedure

Notice: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch assembly.





1. Notice: Refer to Fastener Notice in Service Precautions.

Install the backup light switch with a new gasket.
Tighten the switch to 40 Nm (30 ft. lbs.).





2. Connect the backup lamp connector.