Automatic Transmission Mount Replacement - Front
Automatic Transmission Mount Replacement - FrontRemoval Procedure
1. Install the engine support fixture.
2. Raise the vehicle. Refer to Vehicle Lifting.
3. Remove the left hand splash shield.
4. Remove the right hand splash shield.
5. Remove the 2 bolts from the front transaxle mount.
6. Remove the front transaxle mount through bolt
7. Remove the insulator to the mount bracket.
8. Remove the 2 front transaxle bracket bolts and bracket from the transaxle.
Installation Procedure
1. Notice: Refer to Fastener Notice in Service Precautions.
Install the front transaxle bracket and bolts.
Tighten the transaxle bracket bolts to 64 Nm (47 ft. lbs.).
2. Install the insulator to the mount bracket.
3. Install the front transaxle mount through bolt.
Tighten the transaxle mount through bolt to 52 Nm (38 ft. lbs.).
4. Install the 2 bolts to the front transaxle mount.
Tighten the front transaxle mount bolts to 39 Nm (29 ft. lbs.).
5. Install the left hand splash shield.
6. Install the right hand splash shield.
7. Lower the vehicle.
8. Remove the engine support fixture.