Garnish Molding Replacement - Center Pillar

Garnish Molding Replacement - Center Pillar

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.

1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 2 or SIR Disabling and Enabling Zone 6 in Restraint Systems.
2. Remove the front and rear carpet retainers.




3. Pull out on the center trim panel in order to disengage the clips.

Installation Procedure




1. Position the center pillar trim panel and spoon the weatherstrip flipper over the trim edge, push in on the trim panel in order to secure the clips.
2. Install the front and rear carpet retainers.
3. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2 or SIR Disabling and Enabling Zone 6 in Restraint Systems.