Evaporative Emission Control Canister: Service and Repair

EVAPORATIVE EMISSION (EVAP) CANISTER REPLACEMENT

REMOVAL PROCEDURE




1. Raise the vehicle. Refer to Vehicle Lifting.
2. Disconnect evaporative emission (EVAP) purge pipe (3), vapor pipe (2) and vent hose/pipe (1) from the EVAP canister.




3. Remove the EVAP canister bracket retaining nuts (2).
4. Remove the canister (1) from the EVAP canister bracket (3).

INSTALLATION PROCEDURE




1. Install the EVAP canister (1) to the EVAP canister bracket (3) and position the canister on the underbody.
2. Install the EVAP canister bracket retaining nuts (2).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the nuts to 6 N.m (53 lb in).




3. Connect the EVAP purge pipe (3), vapor pipe (2) and vent hose/pipe (1) to the EVAP canister.
4. Lower the vehicle.