Seat Replacement - Front Bucket

Seat Replacement - Front Bucket

Removal Procedure

1. Move the seat full forward.
2. Remove the seat belt anchor bolt from the front seat assembly.




3. Remove the front seat mounting fasteners and tilt the seat forward.
4. Disconnect the electrical wire harness and remove the push-in fastener from beneath the seat.
5. Remove the seat.

Installation Procedure

1. Install the seat into the vehicle.




2. Connect the electrical wire harness and install the push-in fastener beneath the seat.

Notice: Refer to Fastener Notice in service Precautions.

3. Install the front seat mounting fasteners.

Tighten the fasteners to 45 N.m (33 lb ft).

Important: Verify that the shoulder belt is not twisted.

4. Install the seat belt anchor bolt to the front seat assembly.