42. Piston and Connecting Rod Disassemble

Piston and Connecting Rod Disassemble

Tools Required
^ J24086-C Piston Pin Remover/Installer Set





1. Important: This procedure is to be used for oversized pistons only. Standard size pistons are supplied as an assembly consisting of a piston, piston pin, connecting rod and piston rings.

Using piston ring pliers, remove the piston rings from the piston.





2. Install fork insert J24086-310 into fixture J24086-10 piston pin remover/installer base, which are part of J24086-C.





3. Install the piston and connecting rod assembly onto J24086-10.
4. Install the J24086-107 onto the piston pin and J24086-88A through the fixture and onto J24086-107, which are part of J24086-C.





5. Notice: After the installer hub bottoms on the support assembly, do not exceed 35,000 kPa (5,000 psi) pressure, this could cause damage to the tool.

Press the piston pin from the piston and connecting rod assembly.
6. The piston and pin are a matched set and are not to be serviced separately. Mark, sort organize the piston and the matching piston pin.