Steering Wheel Module Replacement
INFLATABLE RESTRAINT STEERING WHEEL MODULE REPLACEMENT
TOOLS REQUIRED
J 44298 Driver Air Bag Removal Tool
REMOVAL PROCEDURE
1. Remove the steering column trim covers.
2. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3.
CAUTION:
- Refer to SIR Inflator Module Handling and Storage Caution in Service Precautions.
- A deployed dual stage inflator module will look the same whether one or both stages were used. Always assume a deployed dual stage inflator module has an active stage 2. Improper handling or servicing can activate the inflator module and cause personal injury.
- Refer to SIR Caution in Service Precautions.
3. On the back side of the steering wheel are 4 openings for removing the driver inflator module.Place the steering wheel so that 2 of the openings are on top.
4. Adjust and install J 44298 into 2 of the holes.
5. Pull the handle towards the back of the steering wheel, releasing the 2 spring-loaded fasteners at the same time.
IMPORTANT: Seat the air bag removal tool all the way in to perform properly.
6. Turn the steering wheel and open J 44298.
7. Place J 44298 and insert into place and repeat the same steps for the other 2 openings.
8. Pull the driver inflator module gently away from the steering wheel.
9. Remove the connector position assurance (CPA) and the electrical connector for the driver inflator module.
IMPORTANT: Note the driver inflator wire routing positions, the redundant control routing positions, and the horn wire routing positions for the correct re-assembly.
10. Remove the horn grounded lead from the steering wheel.
11. Remove the inflatable restraint module.
12. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping.
INSTALLATION PROCEDURE
1. Connect the horn ground lead onto the steering wheel.
2. Connect the inflator module electrical connector and the CPA.
IMPORTANT: This vehicle is equipped with dual stage frontal air bags. Match the right color connector to the right color opening in the module. Route the driver inflator wires, the redundant control wires, and the horn wires correctly.
3. Align the driver inflator module fasteners to the steering column fastener holes.
4. Push the driver inflator module firmly into the steering column in order to engage the fasteners.
5. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3.
6. Install the steering column trim covers.