Steering Wheel Control Switch

Steering Wheel Control Switch Assembly Replacement

Removal Procedure
1. Remove the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in Restraint Systems.





Important: Release the steering wheel control wire harness from the retainers on the steering wheel shroud to provide slack in the harness.

2. Remove the steering wheel control switches using a small flat bladed tool. Pry the switch out of the steering wheel.
3. Disconnect the electrical connectors.

Installation Procedure





1. Connect the electrical connectors.
2. Align the switches to the opening in the steering wheel.
3. Push the switches into the steering wheel.
4. Attach the steering wheel control wire harness to the retainers on the steering wheel shroud.
5. Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in Restraint Systems.