A/C - Revised Mode/Air Temp. Actuator Service Procedures
Bulletin No.: 05-01-38-013Date: August 11, 2005
SERVICE MANUAL UPDATE
Subject:
Revised Air Temperature Actuator Replacement and Mode Actuator Replacement Procedures
Models:
2005 Pontiac G6
This bulletin is being issued to revise the Air Temperature Actuator Replacement procedure and the Mode Actuator Replacement procedure in the HVAC-Manual sub-section of the Service Manual. Please replace the current information in the Service Manual with the following information.
The following information has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin on the affected page.
Air Temperature Actuator Replacement
Removal Procedure
1. Remove the fuse labeled HVAC CTRL (BATT).
2. Completely open the instrument panel (I/P) compartment door by pressing both tabs that support the stop bumpers. Refer to Compartment Replacement - Instrument Panel (I/P).
3. Remove the air temperature actuator screws.
4. Remove the air temperature actuator.
5. Disconnect the air temperature actuator electrical connector.
Installation Procedure
1. Connect the air temperature actuator electrical connector.
2. Install the air temperature actuator.
Note:
Refer to Fastener Notice in Cautions and Notices.
3. Install the air temperature actuator screws.
Tighten
Tighten the screws to 1.5 N.m (13 lb in).
4. Close the I/P compartment door.
5. Install the fuse labeled HVAC CTRL (BATT).
Mode Actuator Replacement
Removal Procedure
1. Remove the fuse labeled HVAC CTRL (BATT).
2. Remove the left closeout panel.
3. Remove the knee bolster. Refer to Knee Bolster Replacement.
4. Remove the mode actuator retaining screws.
5. Remove the mode actuator.
6. Disconnect the mode actuator electrical connector.
Installation Procedure
1. Install the mode actuator.
Note:
Refer to Fastener Notice in Cautions and Notices.
2. Install the mode actuator retaining screws.
Tighten
Tighten the screws to 1.5 N.m (13 lb in).
3. Connect the mode actuator electrical connector.
4. Install the knee bolster. Refer to Knee Bolster Replacement.
5. Install the left closeout panel. Refer to Closeout/Insulator Panel Replacement - Left.
6. Install the fuse labeled HVAC CTRL (BATT).
Disclaimer