Operation CHARM: Car repair manuals for everyone.

P2769


DTC P2769
Circuit Description
The torque converter clutch (TCC) solenoid valve is an electrical device that is used with the torque converter clutch pulse width modulation (TCC PWM) solenoid valve in order to control TCC apply and release. The TCC solenoid valve attaches to the transmission case assembly extending into the pump cover. The TCC solenoid valve receives voltage through the ignition 1 voltage circuit. The transmission control module (TCM) controls the solenoid by providing the ground path on the TCC solenoid valve control circuit. The TCM monitors the throttle position (TP) voltage, the vehicle speed and other inputs in order to determine when to energize the TCC solenoid valve.

When the TCM detects a continuous open or short to ground in the TCC solenoid valve control circuit, then DTC P2769 sets. DTC P2769 is a type B DTC.

DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC P2769 Torque Converter Clutch (TCC) Enable Solenoid Control Circuit Low Voltage

Conditions for Running the DTC
^ The system voltage is 8 - 18 volts.
^ The engine speed is 500 RPM for 5 seconds.

Conditions for Setting the DTC
DTC P2769 sets when either of the following conditions occurs for 5 seconds:
^ The TCM detects an open in the TCC solenoid valve circuit when the TCC is commanded ON.
^ The TCM detects a short to ground in the TCC shift solenoid valve circuit when the TCC is commanded ON.

Action Taken When the DTC Sets
^ The TCM requests the ECM to illuminate the malfunction indicator lamp (MIL) during the second consecutive trip in which the Conditions for Setting the DTC are met.
^ The TCM freezes transmission adaptive functions.
^ The TCM inhibits TCC engagement.
^ The TCM inhibits 4th gear if in hot mode.
^ At the time of the first failure, the TCM records the operating conditions when the Conditions for Setting the DTC are met. The TCM stores this information as a Failure Record.
^ At the time of the second failure, the ECM records the operating conditions when the Conditions for Setting the DTC are met. The ECM stores this information as a Freeze Frame.
^ The TCM stores DTC P2769 in TCM history during the second consecutive trip in which the Conditions for Setting the DTC are met.

Conditions for Clearing the DTC
^ The ECM turns OFF the MIL after the 4th consecutive drive trip in which the TCM does not send a MIL illumination request.
^ A scan tool can clear the DTC.
^ The TCM clears the DTC from TCM history if the vehicle completes 40 warm-up cycles without a non-emission related diagnostic fault occurring.

Diagnostic Aids
With the TCC engaged, the TCC slip speed should be -20 to +40 RPM.

Test Description
The numbers below refer to the step numbers on the diagnostic table.
4. This step tests for voltage to the solenoid.
5. This step tests the ability of the TCM and wiring to control the ground circuit.
7. This step tests the resistance of the TCC solenoid valve and the automatic transmission (AT) wiring harness.