Valve Rocker Arm Cover Replacement (Right)

Valve Rocker Arm Cover Replacement - Right

Removal Procedure





1. Remove the front suspension support brace.
2. Remove the engine sight cover.
3. Remove the crankcase ventilation hoses/pipes.
4. Remove the ignition coil assembly.





5. Loosen the valve rocker arm cover bolts.
6. Remove the valve rocker arm cover.





7. Remove the gasket (1) from the rocker cover. Discard the OLD gasket.

Installation Procedure

Important:
^ All gasket surfaces should be free of oil and other foreign material during assembly.
^ DO NOT reuse the valve rocker arm cover gasket.
^ The valve rocker arm cover bolt grommets may be reused.





1. Install a NEW gasket (1) into the valve rocker cover lip.





2. Install the valve rocker arm cover onto the cylinder head.

3. Notice: Refer to Fastener Notice in Service Precautions.

Tighten the rocker arm cover bolts.
Tighten the valve rocker arm cover bolts to 12 Nm (106 inch lbs.).
4. Install a new oil fill tube into the rocker arm cover.





5. Install the ignition coil assembly.
6. Install the crankcase ventilation hoses/pipes.
7. Install the engine sight cover.
8. Install the front suspension support brace.