79. Valve Rocker Arm Cover Installation - Right

Valve Rocker Arm Cover Installation - Right





1. Important:
^ All gasket surfaces should be free of oil or other foreign material during assembly.
^ DO NOT use the valve rocker arm cover gasket again.
^ The valve rocker arm cover bolt grommets may be used again if not damaged.

Install a NEW gasket (504) into the valve rocker arm cover.





2. Install a NEW oil fill tube to the valve rocker arm cover





3. Install the valve rocker arm cover onto the cylinder head.

4. Notice: Refer to Fastener Notice in Service Precautions.

Install the cover bolts with grommets.
Tighten the valve rocker arm cover bolts to 12 Nm (106 inch lbs.).





5. Apply threadlock GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the threads of the ignition coil bolts (723).
6. Install the ignition coils (722), wire harness (721), and bolts (723) to the bracket (719).
Tighten the ignition coil bolts to 10 Nm (89 inch lbs.).





7. Apply threadlock GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the threads of the ignition coil bracket bolts (723).
8. Install the ignition coil and bracket assembly (719) and bolts (720).
Tighten the bracket bolts to 12 Nm (106 inch lbs.).