Quick Connect Fitting(S) Service (Metal Collar)

QUICK CONNECT FITTING(S) SERVICE (METAL COLLAR)

TOOLS REQUIRED
- EN-46843 Tool Set, Quick Connect Fitting Release Tool
- J 37088-A Tool Set, Fuel Line Quick Connect Separator

REMOVAL PROCEDURE




1. Before you service any fuel system connection, relieve the fuel system pressure Refer to the Fuel Pressure Relief Procedure.
2. Slide the dust cover from the quick-connect fitting.




3. Use compressed air in order to blow any dirt from the fitting.

CAUTION: Wear safety glasses when using compressed air, as flying dirt particles may cause eye injury.




4. Choose the correct tool for the size of the fitting from J 37088-A or EN-46843 quick release tool kits. Insert the selected tool into the female connector, then push inward in order to release the locking tabs.




5. Pull the connection apart.
6. Using a clean shop towel, wipe off the male pipe end.

NOTE: If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end in order to prevent damage to the O-ring sealing surface. Use a clean shop towel in order to wipe off the male tube ends. Inspect all the connections for dirt and burrs. Clean or replace the components and assemblies as required.

7. Inspect both ends of the fitting for dirt and for burrs. Clean or replace the components as required.

INSTALLATION PROCEDURE




1. Apply a few drops of clean engine oil to the male pipe end.

CAUTION: Always apply a few drops of clean engine oil to the male pipe ends before connecting the fuel pipe fittings in order to reduce the risk of fire and personal injury. This will ensure proper reconnection and prevent a possible fuel leak. During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.




2. Push both sides of the fitting together in order to cause the retaining tabs to snap into place.




3. Once installed, pull on both sides of the fitting to make sure the connection is secure.




4. Reposition the dust cover over the quick-connect fitting.