6. Synchronizers Cleaning and Inspection

Synchronizers Cleaning and Inspection
1. Clean all the synchronizer parts in a suitable solvent. Air dry all the synchronizer parts.
2. Inspect the synchronizer parts for the following conditions:
^ Burrs
^ Cracks
^ Chamfer for excessive wear
^ Free movement of the clutching sleeves on their hubs
^ Worn or damaged clutch teeth
^ Distorted springs

3. Replace synchronizer parts that are worn or damaged. Replace a burred or nicked part that cannot be reconditioned by hand. Use a soft stone or a crocus cloth.





4. Measure the gap between the vertical faces of the blocking ring teeth and the speed gear as follows:
1. Assemble the correct blocking ring with the correct speed gear.
2. The blocking ring must be fully seated on the gear.
3. Use a feeler gauge to measure the forward gear gap.
4. Use a feeler gauge to measure the reverse gear gap.Measure the gap without the wave washer in between the blocking ring and the reverse gear.The nominal gap is 1.27 - 2.16 mm (0.050 - 0.085 inch) for the 1st and 2nd gear.The nominal gap is 1.27 - 2.03 mm (0.050 - 0.080 inch) for the 3rd, 4th, 5th and 6th gear. Replace the friction cones and blocker rings when the gap is significantly less than specified.