Radio Replacement

RADIO REPLACEMENT

REMOVAL PROCEDURE




1. Remove the instrument panel (I/P) accessory trim plate.

IMPORTANT: Perform the radio set up procedure for new and reinstalled radios. Refer to Radio Setup.

2. Remove the radio screws.
3. Pull the radio toward you for access to the connectors.
4. Disconnect the I/P wiring harness connectors and the antenna cable connector from the radio.
5. Remove the radio from the I/P.

INSTALLATION PROCEDURE




1. Position the radio to the I/P.
2. Connect the I/P wiring harness connectors and the antenna cable connector to the radio.
3. Align the radio locator tab to the I/P locator opening. Install the radio.

IMPORTANT: If the radio locator tab is difficult to align to the I/P locator opening, pull the radio toward you and reposition the antenna cable.

4. Install the radio screws.

Tighten the radio screws to 2 Nm (18 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

5. Install the I/P accessory trim plate.
6. Perform the radio set up procedure for new and reinstalled radios. Refer to Radio Setup.