Receiver Replacement - Digital Radio

RECEIVER REPLACEMENT - DIGITAL RADIO

REMOVAL PROCEDURE
1. Remove the instrument panel (I/P) compartment.

IMPORTANT: Do not swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock(R), and "XM Theftlock(R)" will display.

2. Remove the right side outboard I/P insulator.




3. Remove the digital radio receiver nuts (2).
4. Remove the receiver from the bracket.
5. Disengage the connector position assurance (CPA). Disconnect the I/P wiring harness connector from the receiver.
6. Disconnect the antenna cable from the receiver.
7. Remove the digital radio receiver.
8. To remove the digital radio receiver bracket, perform the following steps:
1. Remove the I/P outer trim cover.
2. Disengage the I/P fuse block retainer. Adjust the fuse block outboard slightly for access.
3. Remove the bracket bolts (4).
4. Remove the bracket from the I/P reinforcement (1).

INSTALLATION PROCEDURE




1. To install the digital radio receiver bracket, perform the following steps:
1. Align the bracket to the I/P reinforcement (1).
2. Install the bracket bolts (4).

Tighten the bolts to 10 Nm (89 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the I/P fuse block. Verify that the retainer is engaged.
4. Install the I/P outer trim cover.

2. Connect the antenna cable to the digital radio receiver.
3. Connect the I/P wiring harness connector to the receiver. Install the CPA.
4. Align the receiver to the bracket.
5. Install the digital radio receiver nuts.

Tighten the nuts to 6 Nm (53 lb in).

6. Install the right side outboard I/P insulator.
7. Install the I/P compartment.
8. Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup.