Front (Sedan)
REMOVAL PROCEDURE1. Remove the center pillar lower trim panel.
2. Remove the front seat belt anchor bolt.
3. Remove the front seat shoulder belt guide cover.
4. Remove the front seat shoulder belt guide bolt.
5. Remove the front seat shoulder belt guide from the vehicle.
6. Remove the front seat belt guide clip. Squeeze the guide clip from both sides in order to release the retainers.
7. Remove the front seat belt retractor bolt.
8. Pull the retractor upward in order to disengage the retractor.
9. Remove the front seat belt retractor assembly from the vehicle.
INSTALLATION PROCEDURE
1. Install the front seat belt retractor assembly to the vehicle.
IMPORTANT: Remove any twists in the seat belt webbing before final assembly.
2. Insert the top of the retractor into the mounting slots and pull downward.
3. Install the front seat belt retractor bolt.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the bolt to 41 N.m (30 lb ft).
4. Install the front seat belt guide clip. Ensure the unit locks into position.
5. Install the front seat shoulder belt guide to the vehicle.
6. Install the front seat shoulder belt guide bolt.
Tighten
Tighten the bolt to 41 N.m (30 lb ft).
7. Inspect the front seat shoulder belt guide cover for broken tabs. Replace the cover if the tabs are broken.
8. Install the front seat shoulder belt guide cover.
9. Install the center pillar lower trim panel.
10. Install the front seat belt anchor bolt.
Tighten
Tighten the bolt to 41 N.m (30 lb ft).
11. Inspect the seat belt assembly for correct operation. Refer to Operational and Functional Checks.