Receiver Replacement - Digital Radio

RECEIVER REPLACEMENT - DIGITAL RADIO

REMOVAL PROCEDURE




1. Adjust the left rear compartment trim panel for access. Refer to Compartment Side Trim Replacement - LH Rear in Trunk/Liftgate.

IMPORTANT: Do NOT exchange digital radio receivers between vehicles. Exchanging digital receivers between vehicles will activate the digital radio Theftlock. "XM Theftlock" will be displayed.

2. Remove the receiver bracket nuts.
3. Remove the receiver bracket from the studs.




4. Remove the digital radio receiver nuts.
5. Remove the digital radio receiver from the receiver bracket.
6. Disengage the connection position assurance (CPA) from the electrical connector.
7. Disconnect the electrical connector from the digital radio receiver.
8. Disconnect the antenna connector.
9. Remove the digital radio receiver.

INSTALLATION PROCEDURE




1. Inspect the receiver bracket for foam tape. If the bracket is not equipped, install foam tape as shown (1, 2) to prevent rattles.




2. Connect the antenna connector.
3. Connect the electrical connector.
4. Install the electrical connector CPA.
5. Install the digital radio receiver to the receiver bracket.
6. Install the digital radio receiver nuts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the nuts to 5 N.m (44 lb in).




7. Align the receiver and bracket assembly to the studs.
8. Install the receiver bracket nuts.

Tighten the nuts to 4 N.m (35 lb in).

9. Install the left rear compartment trim panel.
10. Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup.