Coolant Heater Replacement

Coolant Heater Replacement (RPOs L26/L32)
Removal Procedure





1. Drain the cooling system.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Disconnect the coolant heater cord from the coolant heater.
4. Loosen the bolt at the coolant heater but DO NOT remove the coolant heater bolt.
5. Remove the coolant heater.
6. Remove and clean any burrs, compound, paint, or rough spots from the core plug hole.

Installation Procedure





1. Apply sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to:
^ Engine block heater seal
^ Cleaned surface of the engine block heater hole
2. Install the coolant heater by pushing it tight to the block.





3. Position the engine coolant heater element at the 9 o'clock position (2).Final installed position between 10 o'clock (1) and 8 o'clock (3) is acceptable.

4. Tighten the coolant heater bolt until both locking wings draw tight against the inner wall of the engine block.
Tighten the bolt to 2 Nm (17 inch lbs.).

Notice: Refer to Fastener Notice in Service Precautions.

5. Connect the engine coolant heater cord to the engine coolant heater.
6. Fill the cooling system.