Fuel Return Line: Service and Repair

FUEL HOSE/PIPES ASSEMBLY REPLACEMENT

REMOVAL PROCEDURE

IMPORTANT: Clean the fuel connections and surrounding areas prior to disconnecting the lines in order to avoid possible system contamination.




1. Remove the air cleaner intake duct.
2. Remove the brake master cylinder and reposition.
3. Relieve the fuel system. Refer to Fuel Pressure Relief Procedure.
4. Disconnect the fuel feed line (1) from the fuel rail.




5. Open the fuel/brake pipe retainers (1).
6. Remove the fuel feed line from the fuel/brake pipe retainers (1).
7. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.




8. Remove the fuel/brake line retainer bolt.
9. Remove the fuel feed line from the retainer.




10. Remove the fuel/brake line push in retainer from the underbody.
11. Remove the fuel feed line from the retainer.




12. Remove the fuel/brake line retainer bolts.
13. Remove the fuel feed line from the retainer.




14. Open the fuel/brake line retainer (1).
15. Remove the fuel feed line from the retainer.




16. Disconnect the fuel feed (3) and evaporative emission (EVAP) (4) lines from the fuel tank lines (1, 2).
17. Remove the fuel feed line.

INSTALLATION PROCEDURE




1. Position the fuel feed line.
2. Connect the fuel feed (3) and EVAP (4) lines to the fuel tank lines (1, 2).




3. Install the fuel feed line to the retainer.
4. Close the fuel/brake line retainer (1).




5. Install the fuel feed line to the retainer.
6. Install the fuel/brake line retainer bolts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the bolts to 10 N.m (89 lb in).




7. Install the fuel feed line to the retainer.
8. Install the fuel/brake line push in retainer to the underbody.




9. Install the fuel feed line to the retainer.
10. Install the fuel/brake line retainer bolt.

Tighten the bolt to 10 N.m (89 lb in).

11. Lower the vehicle.




12. Install the fuel feed line to the fuel/brake pipe retainers (1).
13. Close the fuel/brake pipe retainers (1).




14. Connect the fuel feed line (1) to the fuel rail.
15. Position and install the brake master cylinder. Refer to Master Cylinder Replacement.
16. Install the air cleaner intake duct.
17. Install the fuel fill cap.
18. Connect the negative battery cable.
19. Perform the following steps to inspect for leaks:
1. Turn ON the ignition for 2 seconds.
2. turn OFF the ignition for 10 seconds.
3. Turn ON the ignition.
4. Inspect the system for leaks.
20. Install the fuel injector sight shield.