Accumulator: Service and Repair

Accumulator and 2-1 Manual Servo Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the filter.





3. Remove the accumulator bolts (131).
4. Remove the manual 2-1 band servo cover bolts (103).





5. Remove the accumulator assembly.





6. Remove the manual 2-1 band servo (106-116).
7. To disassemble, inspect and service the accumulator and 2 - 1 manual servo.

Installation Procedure
1. If disassembled, assemble the 2 - 1 band servo.





2. Install the manual 2-1 band servo (106-116).





3. Install the accumulator assembly.





Notice: Refer to Fastener Notice in Service Precautions.

4. Install the manual 2-1 band servo cover bolts (103).
Tighten the bolts to 25 Nm (18 ft. lbs.).
5. Install the accumulator bolts (131).
Tighten the bolts to 11 Nm (97 inch lbs.).
6. Install the filter.
7. Lower the vehicle.