Torque Converter Clutch Pulse Width Modulation (TCC PWM) Solenoid Replacement

Torque Converter Clutch Pulse Width Modulation (TCC PWM) Solenoid Replacement
Removal Procedure





1. Remove the case side cover.
2. Disconnect and reposition the electrical connectors from the following:
^ Internal mode switch (IMS)
^ 2-3 Shift solenoid valve assembly (315B)
^ Automatic transaxle fluid pressure manual valve position switch assembly (395)





Important: Do NOT remove the bolt (205) that holds the oil pump together.

3. Remove the oil pump bolts (206,207).





4. Remove the oil pump (200) from the valve body (300).





5. Disconnect the torque converter clutch pulse width modulation (TCC PWM) solenoid electrical connector.
6. Remove the TCC PWM solenoid retaining clip (314F).
7. Remove the TCC PWM solenoid (334).

Installation Procedure





1. Install the TCC PWM solenoid (334).
2. Install the TCC PWM solenoid retaining clip (314F).
3. Connect the TCC PWM solenoid electrical connector.





4. Install the oil pump (200) to the valve body (300).





Notice: Refer to Fastener Notice in Service Precautions.

5. Install the oil pump bolts (206,207).
^ Tighten the bolts (207) to 12 Nm (106 inch lbs.).
^ Tighten the bolts (206) to 16 Nm (12 ft. lbs.).





6. Reposition and connect the electrical connectors to the following:
^ Automatic transaxle fluid pressure manual valve position switch assembly (395)
^ 2-3 Shift solenoid valve assembly (315B)
^ Internal mode switch (IMS)
7. Install the case side cover.