Rear Suspension

WHEEL BEARING/HUB REPLACEMENT - REAR

REMOVAL PROCEDURE
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assemblies.
3. Remove the brake drum.

NOTE: Do not hammer on brake drum as damage to the bearing could result.

4. Disconnect the rear ABS wheel speed sensor wire connector.







5. Remove the hub and bearing assembly bolts
6. Remove the hub and bearing assembly from the axle.



INSTALLATION PROCEDURE







1. Install the hub and bearing assembly to the axle in the axle assembly.

NOTE: Refer to Fastener Notice in Service Precautions.



2. Install the hub and bearing assembly bolts.

Tighten
Tighten the hub and bearing to axle bolts to 60 N.m (44 lb ft).

3. Connect the rear ABS wheel speed sensor wire connector.
4. Install the brake drum.
5. Install the tire and wheel assemblies.
6. Lower the vehicle.