Accelerator Pedal: Service and Repair

ACCELERATOR CONTROLS PEDAL REPLACEMENT

REMOVAL PROCEDURE




1. Remove the left sound insulator.
2. Disconnect the release cable (1) retainer from the lever assembly.
3. Remove the retaining nuts.
4. Remove the pedal assembly (2).

INSTALLATION PROCEDURE




1. Install the pedal assembly (2) to the cowl.
2. Install the retaining nuts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the nuts to 30 N.m (22 lb ft).

3. Slip the accelerator cable (1) through the slot in the rod and then install the retainer in the rod, being sure that the retainer is seated.
4. Install the left sound insulator.
5. Inspect for correct opening and closing positions by operating the accelerator pedal. Make sure that the throttle valve reaches a wide open throttle (WOT) position. If not, inspect for a damaged or bent bracket, lever, or other component, or for carpet under the accelerator pedal.