Bracket Assembly Replacement - Onstar Module

BRACKET ASSEMBLY REPLACEMENT - ONSTAR MODULE

REMOVAL PROCEDURE
1. Pull back enough of the carpet and the floor sound deadener for more access, if necessary. Refer to Carpet Replacement - Front in Interior Trim.




2. Remove the OnStar(R) module from the bracket assembly.
3. Remove the retaining nut (2) from the dash pan stud (4).
4. Remove the retaining nut (2) from the hinge pillar stud (3).
5. Remove the bracket assembly (1) from the hinge pillar stud, and the dash pan stud.

INSTALLATION PROCEDURE




1. Install the bracket assembly (1) to the hinge pillar stud (3), and the dash pan stud (4).
2. Install the retaining nut (2) to the hinge pillar stud (3).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten nut to 9.5 N.m (84 lb in).

3. Install the retaining nut (2) to the dash pan stud (4).

Tighten nut to 9.5 N.m (84 lb in).

4. Install the OnStar(R) module to the bracket assembly.
5. Reposition the carpet and the floor sound deadener to a desired appearance, if necessary. Refer to Carpet Replacement - Front in Interior Trim.