Front

INFLATABLE RESTRAINT FRONT END SENSOR REPLACEMENT

REMOVAL PROCEDURE
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 1.

CAUTION: Do not strike or jolt the inflatable restraint front end sensor. Before applying power to the front end sensor make sure that it is securely fastened. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.




2. Remove the pushpin retainers from the hood close out panel.
3. Remove the hood close out panel from the vehicle.




4. Remove the connector position assurance (CPA) from the wiring harness connector.
5. Disconnect the wiring harness connector from the sensor (1).
6. Remove the mounting bolts (2) from the sensor (1).
7. Remove the sensor (1) from the hood latch support bracket (3).

INSTALLATION PROCEDURE




1. Install the sensor (1) to the hood latch support bracket (3).
2. Install the mounting bolts (2) to the sensor (1).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the bolts to 10 N.m (89 lb in).

3. Connect the wiring harness connector to the sensor (1).
4. Install the CPA to the wiring harness connector.




5. Install the hood close out panel to the vehicle.
6. Install the pushpin retainers to the hood close out panel.
7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 1.