Wiper Motor Replacement

WIPER MOTOR REPLACEMENT

TOOLS REQUIRED
- J 39232 Wiper Transmission Separator
- J 39529 Wiper Transmission Installer

REMOVAL PROCEDURE
1. Remove the air inlet grille panel.




2. Disconnect the wiper motor electrical connector.
3. Remove the screws from the wiper drive system module.
4. Remove the wiper drive system module from the vehicle.




5. Using J 39232, disconnect the transmission from the wiper motor crank arm.




6. Remove the wiper motor screws.
7. Remove the wiper motor from the wiper drive system module.

INSTALLATION PROCEDURE




1. Position the wiper motor to the wiper drive system module.
2. Install the wiper motor screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 10 N.m (89 lb in).




3. Apply grease to the motor crank arm pivot.

IMPORTANT: The motor crank arm pivot is a greased joint to the wiper transmission.

4. Using J 39529, connect the wiper transmission arms to the wiper motor crank arm.




5. Position the wiper drive system module to the vehicle.
6. Install the wiper drive system module screws.

Tighten the screws to 10 N.m (89 lb in).

7. Connect the wiper motor electrical connector.
8. Install the air inlet grille panel.
9. Inspect the wipers for proper operation.