Evaporative Emission Control Canister: Service and Repair

EVAPORATIVE EMISSION (EVAP) CANISTER REPLACEMENT

REMOVAL PROCEDURE
- Raise and suitably support the vehicle. Refer to Vehicle Lifting.



- Unlock the quick connect fitting of the on-board refueling vapor recovery (ORVR) vent line by sliding the lock clasp (1) to unlock position.
- Disconnect the ORVR vent line (3) from the evaporative emission (EVAP) canister port (2).




- Disconnect the EVAP canister air inlet line (1) from the vent pipe (2) by pinching both sides of the hose connector.




- Disconnect the EVAP purge hose (1) from the EVAP canister (3).
- Disconnect the electrical connector (4) from the EVAP canister vacuum pump assembly.
- Remove the 3 bolts and the EVAP canister (3) from the vehicle.
- Inspect the EVAP purge system for carbon particle contamination before replacing the EVAP canister.

INSTALLATION PROCEDURE




- Install the EVAP canister (3) to the vehicle underbody and secure with 3 bolts.
- Install the EVAP canister bracket support bolts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the bolts to 19 N.m (14 lb ft).

- Connect the EVAP purge hose (1) to the EVAP canister (3).
- Connect the electrical connector (4) to the EVAP canister vacuum pump.
- Connect the ORVR vent line (2) to the EVAP canister (3).
- Slide the locking clasp of the quick connect fitting into the lock position. on the ORVR vent line.




- Connect the EVAP canister air inlet line (1) to the vent pipe (2).
- Lower the vehicle.