Garnish Molding Replacement - Rear Corner Upper (Sedan)

Garnish Molding Replacement - Rear Corner Upper (Sedan)

Removal Procedure




1. Disable the roof rail SIR system, if equipped. Refer to SIR Disabling and Enabling Zone 8 in Restraint Systems.
2. Remove the lower lock pillar trim panel.
3. Remove the garnish trim fastener cover.
4. Remove the garnish trim fastener.




5. Starting at the bottom, remove the garnish trim by pulling straight out.

Installation Procedure




1. Install the garnish trim into the vehicle.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the garnish trim fastener.

Tighten the fastener to 3 N.m (26 lb in).




3. Install the trim fastener cover.
4. Install the lower lock pillar trim panel.
5. Enable the roof rail SIR system. Refer to SIR Disabling and Enabling Zone 8 in Restraint Systems.