Sunroof Water Gutter Replacement
SUNROOF WATER GUTTER REPLACEMENT
REMOVAL PROCEDURE
1. Apply a double layer of masking tape to the roof panel along the rear edge of the sunroof opening.
2. Cycle the sunroof window to the vent position, then to 25 mm (1 in) rearward.
3. Remove the sunroof module assembly. Refer Sunroof Module Assembly Replacement (CF5) Sunroof Module Assembly Replacement (C3Y).
4. From the underside of the sunroof window track assembly, remove the 3 screws that secure the water gutter to the forward cross-member of the track assembly.
5. Pull downward on the front edge of the water gutter to allow standing bosses to clear the cross-member. Slide the water gutter rearward to release the retaining tabs from the slots on the track assembly.
6. Remove the water gutter from the track assembly.
INSTALLATION PROCEDURE
1. Position the sunroof water gutter to the sunroof window track assembly.
2. Pull downward on the front edge of the water gutter to allow standing bosses to clear the cross-member. Seat the tabs on the water gutter into the slots in the track assembly, and push the water gutter forward until the tabs lock into place.
3. Ensure that all 6 tabs are secured.
4. Install the water gutter screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 2 Nm (18 lb in).
5. Install the sunroof module assembly. Refer Sunroof Module Assembly Replacement (CF5) Sunroof Module Assembly Replacement (C3Y).
6. Remove the masking tape from the roof panel.