Service Procedure

Non-Illuminated Mirror





1. On driver side, remove the assembly by unsnapping the 4 retainers that hold the mirror and cover assembly to the sunshade.





2. Install the mirror and cover assembly by lining up the 4 retainers and applying pressure to the outside edge of the assembly as shown in the illustration above.

3. Repeat the appropriate procedure (illuminated or non-illuminated) on the passenger side.

Illuminated Mirror

1. On the driver side, remove the sunshade from the sunshade retainer.

2. Remove the cover for the fasteners at the sunshade pivot and remove the screws.

3. Remove the sunshade and disconnect the electrical connector for the mirror lamps.





4. Remove the assembly by unsnapping the 4 retainers that hold the mirror and cover assembly to the sunshade as shown in the illustration above.

5. With the assembly face down on the sunshade, unsolder the two wires from the lamp assembly.

6. Solder the wires to the new mirror lamp assembly.





7. Install the mirror and cover assembly to the sunshade. Apply pressure to the edge of the assembly to engage the 4 retainers to the sunshade as shown in the illustration above.

8. Connect the electrical connector for the mirror lamps.

9. Install the sunshade and the screws.

Tighten

Tighten the sunshade screws to 2.5 N.m (22 lb in).

10. Install the fastener cover and place the sunshade back into the retainer.

11. Repeat the appropriate procedure (illuminated or non-illuminated) on the passenger side.