Engine Control Module: Service and Repair

ENGINE CONTROL MODULE (ECM) REPLACEMENT

REMOVAL PROCEDURE

IMPORTANT: It is necessary to record the remaining engine oil life. If the replacement module is not programed with the remaining engine oil life, the engine oil life will default to 100 percent. If the replacement module is not programmed with the remaining engine oil life, the engine oil will need to be changed at 5,000 km (3,000 mi) from the last engine oil change.




1. Using a scan tool, retrieve the percentage of remaining engine oil. Record the remaining engine oil life.
2. Record the preset radio stations.
3. Turn the ignition OFF.
4. Disconnect the negative battery cable.
5. Disconnect the engine control module (ECM) harness connectors.




6. Release the retaining tab located in the battery box lower half using a small screwdriver or other suitable tool.
7. Remove the ECM by lifting upward after releasing the tab.

INSTALLATION PROCEDURE




1. Slide the ECM into the bracket on the front of the battery box.
2. Push down on the ECM until the retaining tab snaps into place.




3. Connect the ECM harness connectors.
4. Connect the negative battery cable.

NOTE: Refer to Fastener Notice.

Tighten the bolt to 17 N.m (13 lb ft).

5. Reset the clock and preset radio stations.
6. If a NEW ECM was installed, the ECM must be programmed. Refer to Control Module References. Programming and Relearning