Camshaft Position (CMP) Sensor Replacement-Exhaust

CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT-EXHAUST

REMOVAL PROCEDURE




1. Disconnect the exhaust camshaft position (CMP) sensor electrical connector (2).




2. Remove the CMP sensor bolt. Intake CMP shown, exhaust CMP similar.
3. Remove the CMP sensor.

INSTALLATION PROCEDURE




1. Lubricate the CMP sensor O-ring seal with clean engine oil.

IMPORTANT: Inspect the CMP sensor for damage, replace as necessary.

2. Install the CMP sensor. Intake CMP shown, exhaust CMP similar.

NOTE: Refer to Fastener Notice.

3. Install the CMP sensor bolt.

Tighten the bolt to 10 N.m (89 lb in).




4. Connect the exhaust CMP sensor electrical connector (2).