Transmission Mount Replacement - Rear

Transmission Mount Replacement - Rear

Removal Procedure
1. Raise and support the vehicle.
2. Remove the left tire and wheel.
3. Using a suitable jack stand, support the rear of the powertrain.





4. Remove the transmission mount to bracket through bolt and nut.





5. Remove the transmission mount to transmission bolts.
6. Disconnect the HO2 sensor Harness from the transmission mount bracket.





7. Remove the transmission mount to frame nuts.
8. Remove the transmission mount and bracket through the left side of the vehicle.

Installation Procedure
1. Install the transmission mount and bracket through the left side of the vehicle.





2. Notice: Refer to Fastener Notice in Service Precautions.

Install the transmission bracket to frame bolts.
Tighten the nuts to 50 Nm (37 ft. lbs.).
3. Connect the HO2 sensor harness to the transmission mount bracket.





4. Install the transmission mount to transmission bolts.
Tighten the bolts to 90 Nm (66 ft. lbs.).





5. Install the transmission mount to bracket through bolt and nut.
Tighten the bolt and nut to 90 Nm (66 ft. lbs.).
6. Remove the jack stand.
7. Install the left tire and wheel.
8. Lower the vehicle.