Pilot Bearing: Service and Repair

Pilot Bearing Replacement

Tools Required
^ J43276 Clutch Pilot Bearing Remover
^ J38836 Bushing Installer and Clutch Arbor

Removal Procedure





1. Remove the clutch.

2. Important: When using the J43276, always secure the J43276-1 tool body using a wrench. Do not allow the J43276-1 tool to rotate. Failing to do so causes damage to the J43276-1 tool body.

Remove the clutch bearing using the J43276.
1. Install the J43276-1 into the clutch pilot bearing.
2. Using a wrench, secure the J43276-1.
3. Insert the J43276-2 into the J43276-1.
4. Rotate the J43276-2 clockwise into the J43276-1 until the clutch pilot bearing is completely removed from the crankshaft.
5. Rotate the J43276-2 counterclockwise to remove the J43276-2 from the J43276-1.
6. Remove the J43276-1 from the tool body.

Installation Procedure





1. Install a 5/8 inch washer (1) onto the J38836 or equivalent. The washer serves as a stop against the crankshaft face and will assist in installing the bearing to the proper depth.
2. Install the new pilot bearing (2) onto the tool.





3. Install a new pilot bearing into the crankshaft using the J38836.
4. Inspect the clutch pilot bearing for proper installation. A properly installed clutch pilot bearing will be installed until flush to the rear of the crankshaft.
5. Install the clutch.