Engine - Revised Cam Position Actuator Fastener Install
Bulletin No.: 05-06-01-027Date: September 16, 2005
SERVICE MANUAL UPDATE
Subject:
Revised Camshaft Position Actuator Fastener Installation Procedure
Models:
2006 Buick Terraza
2006 Chevrolet Impala, Malibu, SS, Malibu Maxx SS, Monte Carlo, Uplander
2006 Pontiac G6, Montana SV6
2006 Relay (AWD)
with 3.5L or 3.9L V6 Engine (VINs N, K, 1 - RPOs LZ4, LZE, LZ9)
This bulletin is being issued to revise the Camshaft Position Actuator Fastener Installation procedure in the Engine Mechanical sub-section of the Service Manual. Please replace the current information in the Service Manual with the following information
The following information has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin on the affected page.
Camshaft Position Actuator Fastener Installation
Note:
Use only a Torx Plus(R) Bit when removing or installing the Camshaft Position Actuator retention Fasteners.
The three camshaft position actuator retention fasteners used on the 3.5L and 3.9L V6 engines are of the Torx Plus(R) design. Refer to the graphic illustration number (1) for the Torx Plus(R) fasteners. The Torx Plus(R) design differs from typical Torx(R) fastener. Use of a standard TORX(R) bit on TORX Plus(R) fasteners may result in a rounded out fastener head, incorrect fastener torque or a damaged Torx Plus(R) bit. The Torx Plus(R) bit size is a T30 and is available from your local tool suppliers.
Disclaimer