2. Crankshaft Balancer Removal

Crankshaft Balancer Removal
Tools Required
^ J41816-A Crankshaft Balancer Remover
^ EN 46359 Puller End Protector





1. Remove the crankshaft balancer bolt and washer.





2. Notice: Do NOT use a power-assisted tool with the special tool in order to remove or install this component. You cannot properly control the alignment of this component using a power-assisted tool, and this can damage the component.

Remove the crankshaft balancer using the J41816-A along with EN 46359 or equivalent.