79. Cylinder Head Installation - Left Side

Cylinder Head Installation - Left
Tools Required
^ J45059 Angle Meter





1. Notice: This component uses torque-to-yield bolts. When servicing this component do not reuse the bolts, New torque-to-yield bolts must be installed. Reusing used torque-to-yield bolts will not provide proper bolt torque and clamp load. Failure to install NEW torque-to-yield bolts may lead to engine damage.

Install the cylinder head locator dowel pins, if necessary.
2. Inspect the cylinder head locator dowel pins for proper installation.
3. Install the cylinder head gasket.





4. Install the cylinder head.





5. Notice: Refer to Fastener Notice in Service Precautions.

Install the new cylinder head bolts.
1. Tighten the cylinder head bolts a first pass in sequence to 60 Nm (44 ft. lbs.).
2. Tighten the cylinder head bolts a final pass in sequence to 95 degrees using the J45059.