99. Engine Prelubing

Engine Prelubing
Tools Required
^ J45299 Engine Preluber





1. Notice: Refer to Fastener Notice in Service Precautions.

Important: A constant/continuous flow of clean engine oil is required in order to properly prime the engine. Be sure to use an approved engine oil as specified in the owners manual.

Remove the engine oil filter, fill with clean engine oil, and reinstall.
Tighten the oil filter to 30 Nm (22 ft. lbs.).
2. Locate the engine oil pressure indicator switch on the left side of the engine and remove.
3. Install the 1/4 inch adapter P/N 509373.





4. Install the flexible hose to the adapter and open the valve.
5. Pump the handle on J45299 to flow a minimum of 1-2 quarts of engine oil. Observe the flow of engine oil through the flexible hose and into the engine assembly.
6. Close the valve and remove the flexible hose and adapter from the engine.
7. Install the engine oil pressure indictor switch.
Tighten the engine oil pressure indictor switch to 16 Nm (12 ft. lbs.).
8. Top off the engine oil to the proper level.