Manifold Pressure/Vacuum Sensor: Service and Repair
MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the intake manifold cover.
2. Disconnect the manifold absolute pressure (MAP) sensor electrical connector.
3. Remove the MAP sensor attaching screw.
4. Remove the MAP sensor and MAP sensor seal from the upper intake manifold.
INSTALLATION PROCEDURE
1. Install the MAP sensor and MAP sensor seal into the upper intake manifold.
2. Install the MAP sensor attaching screw.
NOTE: Refer to Fastener Notice.
Tighten the attaching screw to 6.5 N.m (57 lb in).
3. Connect the MAP sensor electrical connector.
4. Install the intake manifold cover.