Accelerator Pedal: Service and Repair

ACCELERATOR CONTROLS PEDAL REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the accelerator pedal position sensor electrical connector.
2. Remove the accelerator mounting bolts (1) from the accelerator bracket.
3. Remove the accelerator assembly (2) from the vehicle.

INSTALLATION PROCEDURE




1. Install the accelerator assembly (2) to the vehicle.
2. Install the accelerator mounting bolts (1) to the accelerator bracket.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the accelerator pedal nuts to 10 N.m (89 lb in).

3. Connect the accelerator pedal position sensor electrical connector.
4. Confirm that the accelerator sensor connector locking clip is fully secured.
5. Verify the operation of the accelerator pedal.