Washer Solvent Container Replacement

WASHER SOLVENT CONTAINER REPLACEMENT

REMOVAL PROCEDURE




1. Open the hood.
2. Disconnect the solvent container washer hose from the windshield washer hose.
3. Drain the washer solvent from the washer solvent container.
4. Remove the front fender liner.




5. Disconnect the washer level sensor electrical connector.
6. Disconnect the washer pump electrical connector.
7. Remove the washer solvent container nuts.
8. Remove the washer solvent container from the left frame rail.
9. Remove and transfer the following components from the washer solvent container:
- The washer pump assembly and seal
- The washer level sensor and seal
- The solvent container cap
- The solvent container hose

INSTALLATION PROCEDURE
1. Install the following components to the washer solvent container:
- The washer pump assembly and seal
- The washer level sensor and seal
- The solvent container cap
- The solvent container hose




2. Position the washer solvent container to the left frame rail.
3. Install the washer solvent container nuts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screw to 10 N.m (89 lb in).

4. Connect the washer pump electrical connector.
5. Connect the washer level sensor electrical connector.
6. Install the front fender liner.
7. Fill the washer solvent container with washer solvent.




8. Connect the washer solvent container hose to the windshield washer hose.
9. Close the hood.
10. Inspect the washers for proper operation.