P0622
DTC P0622
CIRCUIT DESCRIPTION
The engine control module (ECM) uses the generator field duty cycle signal circuit to monitor the duty cycle of the generator. The generator field duty cycle signal circuit connects to the high side of the field winding in the generator. A pulse width modulation (PWM) high side driver in the voltage regulator turns the field winding ON and OFF. The ECM uses the PWM signal input to determine the generator load on the engine. This allows the ECM to adjust the idle speed to compensate for high electrical loads.
The ECM monitors the state of the generator field duty cycle signal circuit. When the key is in the RUN position and the engine is OFF, the ECM should detect a duty cycle near 0 percent. However, when the engine is running, the duty cycle should be between 5 percent and 100 percent. The ECM monitors the PWM signal using a key ON test and a RUN test. During the tests, if the ECM detects an out of range PWM signal, DTC P0622 will set. When the DTC sets, the ECM will send a class 2 serial data message to the instrument panel cluster (IPC) to illuminate the charge indicator.
DTC DESCRIPTOR
This diagnostic procedure supports the following DTC:
DTC P0622 Generator F-Terminal Circuit
CONDITIONS FOR RUNNING THE DTC
Key ON Test
- No generator, crankshaft position (CKP) sensors, or camshaft position (CMP) sensor DTCs are set.
- The key is in the RUN position.
- The engine is not running.
Run Test
- No generator, CKP sensors, or CMP sensor DTCs are set.
- The engine is less than 3,000 RPM.
CONDITIONS FOR SETTING THE DTC
- During the ignition ON test, the ECM detects a PWM signal is out of range.
- During the RUN test, the ECM detects a PWM signal less then 5 percent for more than 6 seconds.
ACTION TAKEN WHEN THE DTC SETS
- The ECM will store the conditions present when the DTC set as Fail Records data only.
- The malfunction indicator lamp (MIL) will not illuminate.
CONDITIONS FOR CLEARING THE DTC
- The Conditions for Setting the DTC are no longer present.
- A history DTC will clear after 40 malfunction free ignition cycles.
- The ECM receives the clear code command from the scan tool.
TEST
