Rear Toe Adjustment

REAR TOE ADJUSTMENT





1. Loosen the inner toe link cam bolt and nuts.

2. Rotate the cam bolt to the required toe specification settings. Refer to Measuring Wheel Alignment.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Maintain the toe setting while tightening the cam bolt nut.

Tighten the rear suspension adjustment link lock nut to 110 Nm (81 lb ft).

4. Check the toe setting after tightening.

5. Adjust the toe setting if necessary.