Accelerator Pedal: Service and Repair

ACCELERATOR PEDAL POSITION (APP) SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the accelerator pedal position (APP) sensor electrical connector.
2. Remove the APP sensor bolts (1).
3. Remove the APP sensor (2).

INSTALLATION PROCEDURE




1. Install the APP sensor (2).
2. Install the APP bolts (1).

NOTE: Refer to Fastener Notice.

Tighten the bolts to 10 N.m (89 lb in).

3. Connect the APP sensor electrical connector.
4. Confirm that the APP sensor connector locking clip is fully secured.