Fuel Pressure Relief Procedure

FUEL PRESSURE RELIEF PROCEDURE

CAUTION: Refer to Battery Disconnect Caution.

1. Loosen the fuel fill cap in order to relieve the tank pressure. Do not tighten at this time.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Disconnect the fuel pump electrical connector.
4. Lower the vehicle.
5. Start and run the engine until the fuel supply remaining in the fuel pipes is consumed. Engage the starter for 3.0 seconds in order to assure relief of any remaining pressure.
6. Raise the vehicle.
7. Connect the fuel pump electrical connector.
8. Lower the vehicle.
9. Disconnect the negative battery cable in order to avoid possible fuel discharge if an accidental attempt is made to start the engine.