Ignition Coil: Service and Repair

IGNITION COIL(S) REPLACEMENT

REMOVAL PROCEDURE




1. Remove the intake manifold cover.
2. Disconnect the manifold absolute pressure (MAP) sensor electrical connector (1).
3. Disconnect the ignition coil electrical connector (2).




4. Disconnect the left side spark plug wires from the ignition coil.




5. Disconnect the right side spark plug wires from the ignition coil.




6. Remove the ignition coil bolts.
7. Remove the ignition coil.

INSTALLATION PROCEDURE




1. Install the ignition coil.

NOTE: Refer to Fastener Notice.

2. Install the ignition coil bolt.

Tighten the bolts to 4.5 N.m (40 lb in).




3. Connect the right side spark plug wires to the ignition coil.




4. Connect the left side spark plug wires to the ignition coil.




5. Connect the ignition coil electrical connector (2).
6. Connect the MAP sensor electrical connector (1).
7. Install the intake manifold cover.