Oil Level Sensor: Service and Repair

Engine Oil Level Sensor and/or Switch Replacement
Removal Procedure





1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the oil pan drain plug.
3. Drain the crankcase.
4. Reinstall the oil pan drain plug.





5. Disconnect the engine oil level sensor electrical connector.





6. Remove the engine oil level sensor bolt and sensor.

Installation Procedure





1. Notice: Refer to Fastener Notice in Service Precautions.

Install the engine oil level sensor and bolt.
Tighten the bolt to 10 Nm (89 inch lbs.).





2. Connect the engine oil level sensor electrical connector.
3. Lower the vehicle.
4. Refill the crankcase with new engine oil.