Rear Suspension

Wheel Stud Replacement

^ Tools Required
- J 43631 Ball Joint Separator

Removal Procedure
1. Raise the vehicle on a hoist. Refer to Vehicle lifting.
2. Remove the tire and wheel assembly.
3. Remove the brake rotor.





4. Using the J 43631 release the wheel stud from the bearing hub and discard the stud.

Installation Procedure





1. Install a NEW stud into the bearing/hub assembly. Add enough washers (3) in order to draw the stud into the hub.
2. Install and tighten a wheel nut (1) until the head of the wheel stud is fully seated against the back of the bearing/hub flange.
3. Remove the wheel nut (1) and the washers (3).
4. Install the brake rotor.
5. Install the tire and wheel assembly.
6. Lower the vehicle.
7. Check the rear alignment.